Why Is The Door Stopper Not Installed At The Top? This Is The Reason.

Resistant Gate Meeting Point The best place to install a door stopper is about 10 centimeters from the bottom of the door. Some people will install a door stopper above the door in order not to affect the ground, but this is not very beautiful.Resistant Gate Meeting Point Although the door suction may have an impact on a small part of the ground, it is more appropriate to set the door suction under the door to have a certain hiding effect and to play its proper fixing role.

Is The Bathroom Door Stopper Installed At The Top Or Below?
Resistant Door Steel Stopper Usually installed below. First tighten the screws with a small internal angle, and then proceed to the next step after determining the position, drilling and assembly procedures.Resistant Door Steel Stopper Install the ground fixed end firmly, then use the included inner corner tool to fix the screws on it, and the door suction cup will be installed automatically.

How To Install Wooden Door Stopper?
1. First of all, we need to determine the installation method of the door stopper, whether it is installed on the wall or on the ground.
2. If it is installed on the ground, you need to test whether the door suction function is reasonable. Corrosion Swing Gate Bumper Open the door to the maximum position to see whether the door suction function is reasonable. Corrosion Swing Gate Bumper Check whether the door suction goes in a little or comes out a little, and the angle is appropriate. ? Then determine where the door will stop and draw a line on the ground with a pencil.
3. Then we draw the positioning position of the door suction. This is to determine the position of the door and the position of the door suction. The two points are in a straight line, so that its effect will be more significant after installation.
4. After the positions of the door and the door stopper are determined, drill holes in the ground. Just drill a hole. Then use screws to fix the wooden door stopper, and finally install it.
5. At this time, we only need to confirm the position of the door end door stopper. Corrosion Swing Gate Bumper We need to open the door to the maximum position, find the exact position on the door, and then tighten the door end door stopper with screws. After fine-tuning, you can rotate the angle of the door latch so that it fits closely with the door end door latch. Finally, tighten the screws completely and you're done.